Failing to replace step flashings when a cedar shake roof is replaced with a composition shingle roof.
Flashing under cedar siding.
It is always recommended to install step flashing behind stucco dryvit wood panel lap siding vinyl siding cedar shingle siding etc.
Step flashing is used where a roof meets a.
Add felt if needed before nailing the new wood on and prime the new wood on all.
Inspect the sidewall around and underneath the fascia and inside the house for signs of moisture damage and repair any rotted areas.
Building siding flashing finish details for building corners use overlapping 1x4s or 1x6s at outside corners or use 5 4 stock for a heavier look.
Flashing intercepts and directs the flow of water away from the building to designed drainage paths.
Before installing siding make sure that flashings are installed to prevent moisture from entering wall and roof spaces.
Cedar shingle siding must never rest on the horizontal surface of flashing.
How to install step flashing under siding.
A common problem with cement board siding products and some other types of horizontal lap siding is that older installation guidelines called for caulking the joint instead of flashing the joint.
The top of the step flashing is still under the siding or plaster.
You do have to trim the top starter course shingle with a triangle shaped cut to allow this.
Put the bottom step flashing on the starter course then bend the bottom of the step flashing out about 1 to 1 away from the wall.
This has proven problematic over time as caulking the joint results in unsightly surface appearances due to the different textures as well as resulted.
We only caulk butt joints on cedar siding if previously caulked.
Keep water out of your home and running down the roof where it belongs with appropriate use of step flashing.
Fiber cement boards are caulked only when there is no metal flashing behind them.
Flashing should be made from a non corrosive material and should extend a minimum of 2 vertically up the wall.
Otherwise it is possible for water to wick up the shingles and into the wall.
Step flashings on a cedar shake roof are typically installed every 10 inches.
If the kick out and step flashing can t tuck behind the siding screw on cap flashing to cover it then caulk along the top.
Install the flashing before you finish the top of the brick wall as the flashing must go behind the siding as well as behind and under the top row of bricks that angle outward to cover the top.
Flashing is an important line of defense in controlling moisture in wall assemblies.
