I cut the tape so that it laps onto the housewrap above and 3 in.
Flashing standing seam roof against side wall.
Since this was an introductory guide to the basics of standing seam metal roof installations we purposefully left out more technical details such as z bar flashing end wall and valley flashing details however they are covered in the video above if you like to learn more about the components that go beyond the basics.
We are planning to put a standing seam metal roof on the porch and the wall will be lap siding.
Metal roofing chimney flashing kit diy video.
Metal roof flashing can be use to seal gaps between roof walls.
Standing seam trim details a brief guide to the various trims used for standing seam metal roofing as well as how they are installed.
I understand that the flashing must go under the siding but i am concerned about the workers walking on the metal roof while installing the siding.
Metal roof flashing is a galvanized sheet metal bent at right angles with about eight to 12 inches on each side of the angle.
Our trim products include angles channels drip cap flashing and more.
Other flashings include gable trim which runs up the sloped ends of the roof and drip edge or eave trim.
Flexible flashing tape seals the eave to the wall.
Fabral metal wall and roof systems.
This guide is does not cover some aspects of installation.
See our installation guide for more info.
The final thing to do is install the end wall trim.
Above the roof sheathing.
Before we install the end wall flashing we have to apply tape sealant to the top of the z trim so that there s a water tight barrier between the end wall flashing and the top of the z.
Butyl sealant tape or tube sealant should be used under all z channel.
Installing the sidewall and endwall at a dormer location.
Standing seam roof trim.
The new house we are building has a porch that meets a wall on the second floor.
Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia.
Abc manufactures custom standing seam metal roof and wall panel trim to suit your building s needs.
I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall.
These kinds of houses often have a roof that butts against a wall.
