Start by making an outline on the siding where you want to position the ledger board.
Flashing house siding.
It is always recommended to install step flashing behind stucco dryvit wood panel lap siding vinyl siding cedar shingle siding etc.
Traditionally the flashing was installed and hidden under the siding.
And be capped on top with either a preformed metal drip cap or a custom flashing installed under the sheathing wrap.
Use a felt paper spline wrapped around the corner and extending 6 inches beyond the corner board to protect the joints where the siding meets the corner boards see figure 1 5 at left.
If you want siding for your home that looks great and is durable but requires little maintenance look no further.
But unlike fiber cement siding wood is almost sure to rot.
The water table should overlap the foundation by about 1 in.
Vinyl siding is designed to withstand weather and resist moisture damage.
In certain instances flashing may need to be installed on the exterior of siding.
Today the flashing is on top of the siding.
This flashing should not be seen for it disrupts the architectural balance of the.
However in most instances step flashing should be installed behind siding.
This all important water barrier should extend up the wall at least 4 in.
Inspect the sidewall around and underneath the fascia and inside the house for signs of moisture damage and repair any rotted areas.
Many types to choose from.
Then slip flashing behind the siding covering the top edge of the ledger.
It is ideal for siding applications from new home construction utility buildings planters dog houses and other remodeling or do it yourself projects.
Many traditional homes have a wide board called the water table that runs around the house along the foundation and supports the first piece of siding.
It plywood siding is an all wood exterior grade panel.
That is fine but it must still look like the flashing is behind the siding.
Lots of materials can be used for flashing.
Make the outline large enough to include space for the deck boards on.
Add felt if needed before nailing the new wood on and prime the new wood on all.
It is at the back of the porch roof where the roof meets the house siding.
When it comes to the deck a strip of flashing is brought down the wall of the house and over the top of the ledger the piece of dimensional lumber attached to the house at the edge of the deck.
If the kick out and step flashing can t tuck behind the siding screw on cap flashing to cover it then caulk along the top.
It can have the look of wood siding without the ongoing work and expense.
Plywood siding features a rough sawn textured face for a beautiful rustic appearance.
When it comes to flashing siding corners many builders simply use a 1x wood corner.
Plywood siding is an all wood exterior grade panel.
